I have the Ryet Aircode 3D printed saddle, full carbone one, and I kind of like it. I would like to try some 155 mm wide 3D printed saddle. Any advices?
View original forum comment in Chinertown-Forum: Component Deals & Selection → 3D Printed Saddles
The reviewer tested the RYET 3D printed carbon bike saddle for about one and a half to two months. They state it is very comfortable, more so than their stock Trek saddle, and relatively lightweight.
AI-Summary
Pros
Very comfortable
More comfortable than the reviewer's stock Trek Domane SL5 saddle
Comfortable even when riding on aero bars for 3+ hours with no discomfort
Relatively lightweight (165-185g for the carbon version)
Cons
The saddle is on the harder side
Poor customer service from the official RYET AliExpress store
The comfort upgrade over a decent stock saddle was only slight
Key Points
Carbon version weighs 165-185g
Plastic version is about 70g heavier
Purchased for $51.74, but can be found for under $40
MyBike.parts
